I will post engine build specs for these engines as soon as

I get the information gathered

This Tunnel Port was built for Roy Kumerow for his Cobra Kit Car

and was Dynoed at Koffel's Place in Huron, Ohio

The torque curve is amazing through the entire RPM range

with the lowest number at 553 and a whopping 573 at only 2800 RPM

Horsepower was at 674 at 6400 RPM. Roy said that was enough

and didn't go for any bigger numbers at a higher RPM although ths engine

has all the good stuff to go much higher.

This Cammer was Dynoed at Koffel's Place in Huron, Ohio

The big carbs first used had a flaw in the fuel metering and were sent back for repair

and replaced with a set of 750cfm carbs complete with air horns, choke plate

and vacume secondaries off of a street engine build.

Once again a very good torque curve starting pretty high at low RPM.

The horsepower isn't bad either with 837 at 7000 RPM

Dove Manufacturing Inc. 27100 Royalton Rd Columbia Station,Ohio 44028 Phone(440)236-5139 Fax(440)236-3582